Hot Water Systems & Safety (Including G3 Unvented HWS) in Bristol & Yate
Hot water systems and their safety devices, including G3 unvented cylinders: servicing, repairs and replacement of cylinders, valves, expansion vessels and immersions.
Unvented hot water cylinders store hot water at mains pressure, which gives you strong showers but also means they must be installed and maintained by someone with the right qualification. ARV Plumbing and Maintenance is G3 qualified to install, service and repair unvented hot water systems (HWS), and Water Regulations qualified.
We work on unvented and traditional open-vented cylinders and cold water storage tanks in homes across Bristol, Yate, Bath and South Gloucestershire.
Hot water system and safety work
- Annual unvented cylinder servicing
- Pressure relief and temperature/pressure relief valve replacement
- Expansion vessel checks, recharging and replacement
- Pressure reducing valve and inlet control group repairs
- Immersion heater and thermostat replacement
- Unvented cylinder replacement and new installations
- Open-vented cylinders, cold water tanks, ball valves and insulation
Signs your cylinder needs attention
- Water dripping from the tundish or the discharge pipe outside
- No hot water, or hot water that runs out much faster than it used to
- Banging, hissing or knocking from the cylinder cupboard
- Pressure that rises when the water heats up
- A cylinder that hasn't been serviced in over a year
Why unvented cylinders need servicing
An unvented cylinder relies on several safety devices working correctly: the pressure reducing valve, expansion vessel, expansion relief valve and temperature/pressure relief valve. Manufacturers typically require an annual service to keep the warranty valid, and it's the best way to catch a failing valve before it becomes a leak.
A service includes checking and recharging the expansion vessel, testing the safety valves, checking the incoming pressure and inspecting the discharge pipework and tundish. You'll get a record of the service for your warranty.
Water from the tundish? Don't ignore it
Water running through the tundish means a safety valve is opening. Often it's a flat expansion vessel or a worn valve, but it should be checked promptly. If water is discharging continuously or the cylinder is very hot, switch off the heat source and call us.
Installing or replacing an unvented cylinder is notifiable work under Building Regulations Part G3, and we'll make sure the correct paperwork is completed. We're not Gas Safe registered, so where the cylinder is heated by a gas boiler we work on the cylinder and water side only.
Areas covered
We carry out hot water systems & safety (including g3 unvented hws) work across Bristol, Bath and South Gloucestershire from our base in Yate, including:
Hot Water Systems & Safety (Including G3 Unvented HWS): frequently asked questions
Need a plumber?
Call for emergencies or get in touch for a free, no-obligation quote.